THE LEVITATOR

KNOW-HOW

This is a device capable of generating a lifting force ten (or more) times higher than its own weight. = Its performance is in the order of hanging one ton with one KW. It also can pus= h in horizontal direction, being useful for propulsion, but then it needs much m= ore power.

DIAGRAM 1

Observe the diagram. The hea= vy iron disk is the LM (Levitating Mass). Electrodes (green and red) are conne= cted to -1200 KV and +1200 KV of continuous voltage. They can be hollow pipes or= any material covered with a thin metal layer. The insulating material must be w= ell stuck to the LM. It is made up of silicon rubber or epoxy for high voltage,= at least 5 cm thick, eliminating bubbles by vacuum technology. It must have a (very) slig= ht conductivity to avoid charge-carrier migration. Moreover, it must bear mechanical vibration in the order of 500 Hz (or more). Consult high voltage experts.

There are toroidal coils aro= und the electrodes as to move electric charges inside them. <= /p>

Alternated current in toroid= al coils generates accelerating effect by pulses in the LM. =

DIAGRAM 2

Diagram 2 shows current (pow= er) in the toroidal coils. X axis is time; Y axis is current. It has a continuous = component: the half of alternated current's peak-to-peak value, so as to achieve a variation between zero (a) and maximum (b, yellow zone) of only one polarit= y. Without continuous component it does not work. Inverting polarity of contin= uous component, direction of the pushing force is inverted.

Inputting the coil-system's resonance frequency is recommendable.

Voltage and current values d= epend on the coil's impedance. Between b and c the levitating force is represented (striped zone).

Designing coils, frequency c= an be in the order of 500 cycles per second. If accelerating effect of the LM is = 20 G (200 m/s^{2) it
can lift 1 ton needing 1 KW. Increasing frequency performance increases (ne=
eded
power deceases) in linear ratio.
Decreasing accelerating value, needed power decreases by square rati=
o,
but lifted weight divided by weight of LM decreases by linear ratio. <=
/o:p>}

WARNING! A device of one ton= that can lift 10 tons must be totally shielded around by (drinking) water of at least 20 cm thick to avoid biological damage and electric disturbing (communication equipments, computers, etc.). The megavoltage system used in this levitator generates a special kind of parasite electric currents. A simple metal shee= t is not enough to stop such effect. Switching off the levitator, every harmful effect ceases. Do not avoid the water-shield.=

According to 20th century's theories, the described device does not work; but it did not study such theories, then it works. Don’t forget: above polarization of 1022 kilovolts current electromagnetic knowledge changes dramatically.

The theoretical explanation = is in the Spanish section.

Nevertheless, the following = is a "telegraphic report" about an alien theory.

Particles (named "eteron", much smaller than atoms) fill space compactly, like cav= iar. If an eteron is compressed to smaller diameter it absorbs energy; if it expands, it returns the energy. Eterons of space (the eter) is a medium that conducts gravity and light as waves. Gravitons are simple pressure-waves; photons are gravitons that have acquired electric vector.=

If an object moves, it must = make place ahead among eterons. An atom (atom means any nuclear particle) compre= sses and absorbs eterons ahead. Then the atom becomes heavier (mass excess) and = it flattens in the moving direction. After a quantum interval (mass x time =3D constant) such atom emits the mass excess behind; then released energy push= es it ahead to compress the next amount of eterons. Like if a wave crossed the atom, in opposed direction, at the speed of light. Time is the wave's perio= d. Such wave is the "intron", the wave of inertia. Actually, this is= the mechanism of inertia. Matter has no intrinsic inertia.

Pushing an atom against eter= , it generates introns (speed, kinetic energy). Then the atom is moving with reg= ard to the eter. If eter is pushed against fixed matter, it also generates intr= ons in the matter. Then such matter is still with regard the environment and mo= ving with regard to the eter, or, eter is moving against the matter and with reg= ard to the environment. Every movement with regard to eter generates introns. <= o:p>

In the levitator eter is for= ced downwards against the heavy iron disc generating introns (speed) upwards. <= o:p>

Eter is forced by the "= eter pump". Near to the iron disc at the lower side, high voltage electrodes ionize eter. Positive eter-ions enter into the negative electrode and vice versa. Eter-ions (sub-electricity) flow due to toroidal coil's field at much higher speed than light (long story) to the opposed (upper) side of the iron disc; there they regenerate neutral eterons pushing them against the upper side of the iron disc, downwards, generating introns (speed upwards). Such speed of the iron disc makes the levitating force.

Summarizing, eter disappears= at the bottom and appears on the roof of the iron disc. Energy is input by the toroidal coils. Megavoltage system does not consume energy; its role is polarization only. The device called "eter-pump" needs at least 1= 022 kilovolts, better 1200 KV. With lower voltage it simply does not work at al= l. That is why earthlings have not discovered such a simple thing till now.